Task: Configure EIGRP 100 and make sure all the routers are able to form neighbor relationship and learn the best route using EIGRP. Verify the neighbor table, routing...
Task: Create VLANs as given in the topology Switch>enable Switch#configure terminal Enter configuration commands, one per line. End with CNTL/Z. Switch(config)#vlan...
Pre-requisites for this LAB: Configure VLANs and assign the switchports to their specific vlans as mentioned in the topology. Refer to the VLAN Configuration LAB if you...
Switch#show vlan brief Task: Create VLAN10 & VLAN20 on SW1 Switch#configure terminal Enter configuration commands, one per line. End with CNTL/Z...
Configure SSH on R1 R1 Router>enable Router#configure terminal Router(config)#hostname R1 R1(config)#ip domain name BITXPERT.LOCAL R1(config)#ip ssh version 2 Please...
Configure the IP Address as given in the Topology. R1 R1>enable R1#configure terminal R1(config)#interface Ethernet 0/2 R1(config-if)#ip address 2.1.2.1 255.255.255.0...
Prerequisite for this LAB Design the topology Assign the IP Address according to the diagram Make sure that interfaces used should be in UP UP State TASK: Configure...
Design the topology (Connectivity) Assign the IP Address according to the diagram Make sure that interfaces used should be in UP UP state TASK: Configure Static Routing...
TASK: Design the topology as per the above diagram Configure IP Addresses as per the diagram and rules Verify the Interface status using the following command ...